Plug replacement

[Gearheadgregg]

It was not like this when I plugged it in last time ,,, replace plastic housing and clean existing connectors or re solder all new , what is the best easy option TIA, Greg

[daves79x]

Take a Dremmel with a thin cut-off wheel and cut the plastic off the connectors. You will be able to re-use them most of the time, just clean them up and insert into the new connector.

Dave

[Gearheadgregg]

Ok thanks, really didn't think anyone would need to cut off and install new prong connectors , Clean and a mild squeeze to the female connector , Also found a nice Vid to help pull the prongs out for anyone trying to figure out removal https://www.youtube.com/watch?v=gE-hRjrLuyQ

[Larry Zimmer]

And, be certain to cover everything with a generous amount of dielectric/silicon grease before connecting things.

[herdygerdy]

Looks like you've been shopping at www.cycleterminal.com! Gotta love those guys.

If you are keen to keep the OEM look, use a thick bright red 'Sharpie' permanent marker pen and 'colour in' all over the exterior of the white plastic housing so it becomes red, just like your original.

Works a treat and looks good too. Hard to pick from OEM then.

[Larry Zimmer]

Looks like you've been shopping at http://www.cycleterminal.com! Gotta love those guys.

If you are keen to keep the OEM look, use a thick bright red 'Sharpie' permanent marker pen and 'colour in' all over the exterior of the white plastic housing so it becomes red, just like your original.

Works a treat and looks good too. Hard to pick from OEM then.

[Gearheadgregg]

Looks like you've been shopping at http://www.cycleterminal.com! Gotta love those guys.

If you are keen to keep the OEM look, use a thick bright red 'Sharpie' permanent marker pen and 'colour in' all over the exterior of the white plastic housing so it becomes red, just like your original.

Works a treat and looks good too. Hard to pick from OEM then.

Ok thanks gave up looking for a Red plug

[Gearheadgregg]

And, be certain to cover everything with a generous amount of dielectric/silicon grease before connecting things.

Thanks so humid up here in the summers moisture is a real pain , Greg