1979 CYLINDERS ON 1982 ENGINE

[sostaats]

What do I need to do to use a set of early model cylinders on a 1982 engine. I vaguely remember that some of the holes needed to be drilled out but it was about 20 years ago when I last gave this any thought. Now I've got a 82 smoker that I need to rebuild and parts for a early model. Thanks for any advise.

[CBX-tras]

Yes, just enlarge the 4 holes in the center and the 2 on either end where the smaller studs are, on the early motor.

[Rick Pope]

Howdy Steve! Where ya been? It's been too long since we got together.

[daves79x]

JR - isn't it just the four center studs? The outside two on each side are the same small ones, according to my memory and the parts book.


Dave

[CBX-tras]

JR - isn't it just the four center studs? The outside two on each side are the same small ones, according to my memory and the parts book.


Dave

Yes, I stand corrected. Working from memory without the parts in front of me.

[sostaats]

Howdy Steve! Where ya been? It's been too long since we got together.

Retired and moved from MN to AZ built myself a three car garage, all is good

[sostaats]

Yes, just enlarge the 4 holes in the center and the 2 on either end where the smaller studs are, on the early motor.

Enlarged the 4 center holes and it went right together. Thanks.